Raymarine ST2000+ manuals
ST2000+
Table of contents
ST2000+
Table of contents
- Table Of Contents
- Table Of Contents
- Chapter 1: Introduction
- Specifications
- About this handbook
- Product disposal
- Chapter 2: Using the Tiller Pilot
- Using Auto mode
- Changing course
- Displaying navigation information
- Automatic deadband control (Auto Seastate)
- Operating hints – trim changes
- Switching display illumination on and off
- Returning to Auto from Track mode
- Tidal stream compensation
- Dodges in Track mode
- Warning messages in Track mode
- waypoint advance
- Using WindTrim mode
- Exiting WindTrim mode
- Chapter 3: Maintenance & Fault Finding
- Product support
- Chapter 4: Installing the Tiller Pilot
- emc installation guidelines
- Installing the tiller pin and mounting socket
- Basic installation
- Installation accessories
- Pedestal socket mounting
- Cabling and socket installation
- Mounting the socket
- Power supply
- SeaTalk cabling
- NMEA cabling
- Functional tests
- Checking the navigation interface
- Checking the wind instrument interface
- Checking the SeaTalk interface
- Initial sea trial
- Adjusting autopilot performance
- Introduction
- Calibration features
- Calibrating the tiller pilot
- Calibration Level 9: magnetic variation
- Calibration Level 11: boat's current latitude
- limited warranty
Related products
Autohelm ST2000ST1000+ST7000ST2000 Plus Tiller PilotsAutohelm ST3000Autohelm ST6000autopilot ST4000+EV200Autohelm 2000SmartPilot S1000Raymarine categories
Marine Equipment
Monitor
GPS
Marine GPS System
Autopilot System
Fish Finder
Transducer
Radio
Thermal cameras
Marine Radar
manualsdatabase
Your AI-powered manual search engine