Raymarine SmartPilot SPX-30 manuals
SmartPilot SPX-30
Table of contents
- installation guide
- Table Of Contents
- emc installation guidelines
- product disposal
- Chapter 1:Before you begin
- Certified installation
- Product documents
- Chapter 2:System overviews
- SeaTalkng
- SeaTalk
- NMEA 0183 / other manufacturers' equipment
- Autopilot system components
- Required additional components
- Autopilot controller
- Drive unit
- Clutch
- Power and drive cables
- Circuit breaker and fuse information
- Solenoid drives
- Grounding the SPX SmartPilot
- Compass
- Rudder reference
- Sleep switch (optional)
- Test the system
- Secure all cables
- Chapter 5:NMEA 0183 sentences
SmartPilot SPX-30
Table of contents
- Table Of Contents
- Chapter 1 Introduction
- Important information
- emc installation guidelines
- Chapter 2 Planning the installation
- Installation checklist
- SeaTalk ng autopilot system
- nmea 2000
- SeaTalk autopilot system
- Parts supplied
- Required additional components
- Chapter 3 Cables and connections
- General cabling guidance
- SPX-10 / SPX-30 connections overview
- Power and drive cables
- Fuses and circuit protection
- Grounding
- SeaTalk connection
- NMEA 0183 connection
- Compass connection
- Rudder reference connection
- Chapter 4 Installation
- Location requirements for SPX course computers
- Initial checks for the autopilot installation
- Chapter 5 Maintenance and support
- Service and maintenance
- Raymarine customer support
- Appendix A Technical specification
- Appendix B NMEA 0183 sentences
- Appendix D SeaTalk accessories
SmartPilot SPX-30
Table of contents
- Table Of Contents
- Table Of Contents
- emc conformance
- product disposal
- Chapter 1:Procedures
- Rudder reference information
- Commissioning procedures
- Step 2 - Checking SeaTalk and NMEA connections
- Step 3 - Checking rudder bar and steering operating sense
- Step 4 - Dealer calibration settings
- Finishing dockside preparation
- Swinging the compass
- Aligning compass heading
- Aligning rudder bar
- AutoLearn
- Commissioning complete
- Adjustable parameters
- Adjusting
- AutoTrim
- Chapter 2:SPX system settings
- Accessing the Calibration modes
- Display calibration
- Setting up data
- User calibration
- AutoTack (sail boat only)
- WindTrim (sail boat only)
- Seatrial calibration lock
- Drive type
- Rudder limit
- Response level
- AutoTack
- Cruise speed
- System defaults
- SmartPilot X-Series Specifications
- Glossary
- Index
Related products
SmartPilot SPX-10SmartPilot S1SmartPilot S1GSmartPilot S1000SmartPilot SeriesSmartPilot VeradoSPX 30SmartPilot S1 Wheel PilotSmartPilot S1 Tiller PilotSmartPilot X-5 ST6002 ControllerRaymarine categories
Marine Equipment
Monitor
GPS
Marine GPS System
Autopilot System
Fish Finder
Transducer
Radio
Thermal cameras
Marine Radar
manualsdatabase
Your AI-powered manual search engine