30 Copyright © 2014 Linear LLCPROGRAMMING NAVIGATIONWhen the installer is using the System Configurationmenus, the Control Panel will present each programmingquestion sequentially. Most programming questions have asingle numeric value response or a simple enabled/disabled selection. Some programming questions have sub‐options that can be set. These sub‐options are displayedfor the question selected and can be accessed throughnavigation keys on the display.NAVIGATION ARROWS & GO TO BUTTONThe programming question screens display up, down, left,and right navigation arrows. Use these arrows to scrollthrough the programming questions and to select sub‐options.Press the Go To button and then enter a two (2)‐digit codeto jump directly to a programming question. See“Programming Question Table” on page 33. The Go Tobutton changes to Cancel when waiting for you to enter aquestion number. Press Cancel to back out.Figure 43 Navigation Arrows & Go To ButtonQUESTIONS WITHOUT SUB-OPTIONSMost of the programming questions do not have sub‐options. They navigate as follows. Questions without sub‐options do not display a Skip button.Figure 44 Questions without Sub-options• The ↑ and ↓ arrows select the next or previousprogramming question.• The ← and → arrows choose values for the quesƟon ormove the cursor left and right along the white dataentry field.QUESTIONS WITH SUB-OPTIONSSome of the programming questions have sub‐options.They navigate as follows. Questions with sub‐optionsdisplay a Skip button during the question. The Skip buttonadvances to the next programming question/section.• The ↑ and ↓ arrows select the next or previousprogramming sub‐question.• The ← and → arrows choose values for the quesƟon ormove the cursor left and right along the white dataentry field.Figure 45 Questions with Sub-options