2gig Technologies Go!Control Panel Installation & Programming Manual
Also see for Go!Control Panel: User guideInstallation and Programming Technical TrainingUser guide
                                                                              | |
Contents
| 
Go!Control Wireless Security System | Installation and Programming Guide70 Copyright © 2014 Linear LLCTelephone TestUse this test to verify the land‐line connection from thepanel’s built‐in digital communicator and Central Station.1 At the Toolbox (3 of 3) screen, press the Telephone Testbutton.2 At the Enter Master Code to Access Telephone Testscreen, enter the master code.The top area of the Telephone Test screen shows theControl Panel actions and the bottom area shows theresults.3 Press the ↓ and ↑ arrows to review the acƟons andresults.4 When complete, press OK to return to the Toolbox (3 of3) screen.RESTORE DEFAULT SYSTEMCONFIGURATIONYou can restore the Control Panel settings back to its factorydefaults. There are two (2) types of reset options: Soft andhard.Soft ResetA soft‐reset lets you select which settings to restore back tothe factory defaults.To perform a soft‐reset:1 At the Installer Toolbox screen, press the RestoreDefault button.The Restore Default System Configuration screenappears.2 At the Restore Default System Configuration screen,select one or both checkboxes:2a Zones. Place a checkmark in this box to replacedata for ALL sensors with the factory default values.AND/OR2b Console. Place a checkmark in this box to replace allof the programming answers with the factorydefaults. This erases the user codes, resets thebacklight timeout to five (5) minutes, and resets theBrightness/Volume settings.IMPORTANT: This action does not restore factory defaultsettings for Z‐Wave questions Q79‐Q83.Hard ResetA hard‐reset restores all of the programming settings backto the factory defaults.NOTE: Before performing a hard reset, Q44: Lock InstallerProgramming must be set to option (1) or (2) and Q45:Lock Default Programming must be set to (0). See "Q44:Lock Installer Programming (0‐2)" on page 60.To perform a hard reset:1 Remove the Control Panel cover and completelydisconnect all power to the Control Panel.2 On the inside back of the Control Panel, plug in thebackup battery.3 Press and hold down the Emergency and Homebuttons.4 Continue to hold down the Emergency and Homebuttons and then connect DC Power to the ControlPanel.5 Release the buttons only after both the Emergencyand Home buttons are lit and the Control Panel screenappears. |
Related manuals for 2gig Technologies Go!Control Panel
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine