Adding a BRI-ST Digital Line Card 151passes you three digits, you need no translator entries in the Dial Planconfiguration file. If the carrier passes you four digits, you could add asingle set of translator entries to the configuration file to remove the firstdigit (4) and use the remaining three digits as the internal extension.Enabling the AutoDiscover FeatureTo enable the Auto Discover feature for digital line cards:1 Log in to the NBX NetSet utility using the administrator username andpassword.2 Click System-wide Settings > Auto Discovery.3 Enable Auto Discover Other Devices.4 Click OK.Inserting the BRI-STDigital Line CardWhen you insert the BRI-ST card into the chassis, you may leave thesystem powered up. The Auto Discover process begins as soon as thesystem senses the new card.To insert the BRI-ST card into the chassis:1 Write down the MAC address of the BRI-ST card.2 Insert the BRI-ST card into an available slot on the chassis. Slide the cardinto the chassis until you feel it touch the connectors. To seat the BRI-STcard into the connectors, press firmly on both sides of the front of thecard.CAUTION: If you cannot seat the card with light pressure, remove it andcheck for obstructions and misalignment.3 Tighten the left and right screws on the front of the card to secure it tothe chassis.4 Wait at least 3 minutes for the system to discover the card and updatethe database.When you insert the BRI-ST Digital Line Card, it begins an initializationsequence. Also, because you enabled Auto Discovery, the systemrecognizes the addition of the card and begins to update its database.Allow at least 3 minutes for both of these processes to be completed. Ifyou attach a cable to the CONSOLE port on the BRI-ST card and useHyperterminal software to view the text output, you can see statusmessages. See “Connecting a Computer to a Console Port” inChapter 11.
