3Com 3C905-TX User Manual

Also see for 3C905-TX: Installation guide

Contents

3Com 3C905-TX User Manual Manual pdf 29 page image

Installing NetWare Drivers 3-9Driver Installation with NetWare 3.11To install the 4.x server driver while running NetWare 3.11,follow these steps:1 Copy the contents of the appropriate \NETWAREsubdirectory to the boot partition of the server‘s hard disk.2 When you start the server, enter the following commands:load C:LSLENH.NLM [Enter]load C:3C59X.LAN PORT=XXXX [Enter]where XXXX is the adapter’s port address. (To determine theport address, refer to the section “Finding the Adapter’s PortAddress” earlier in this chapter. )If the load sequence is not followed, the system will notoperate correctly.3 When this has been done, bind the protocol to the driveras usual.When running the 3C59X.LAN driver with NetWare 3.11, youmust update the MONITOR.NLM file that accompaniedNetWare 3.11 with the MONITOR.NLM file from Novell. Forthe latest NLMs, contact Novell.Driver Installation with NetWare 3.12To install the 4.x server driver while running NetWare 3.12,follow these steps:1 Copy the contents of the appropriate \NETWAREsubdirectory to the boot partition of the server‘s hard disk.2 When you start the server, enter the following commands:load C:3C59X.LAN PORT=XXXX [Enter]where XXXX is the adapter’s port address. (To determine theport address, refer to the section “Finding the Adapter’s PortAddress” earlier in this chapter.)