3Com 3C905-TX User Manual

Also see for 3C905-TX: Installation guide

Contents

3Com 3C905-TX User Manual Manual pdf 30 page image

3-10 CHAPTER 3: INSTALLING NETWORK DRIVERS3 When this has been done, bind the protocol to the driveras usual.This concludes the procedure for installing a single adapter ina PCI server.Multiple PCI Adapters in a ServerIf you are running NetWare and have installed multipleadapters in a PCI computer that is functioning as a server,follow the instructions in this section.The 3C59X EtherDisk diskette contains a NetWare 4.x serverdriver (3C59X.LAN) and the NetWare Loadable Modules(NLMs) that enable the NetWare 4.x driver to be used withNetWare 3.11 or 3.12 software. These files are found in the\NETWARE subdirectory.Driver Installation with NetWare 3.11To install the 4.x server driver while running NetWare 3.11,follow these steps:1 Copy the contents of the appropriate \NETWAREsubdirectory to the boot partition of the server‘s hard disk.2 When you start the server, enter the following commands:load C:LSLENH.NLM [Enter]load C:3C59X.LAN PORT=XXXX NAME=X [Enter]load C:3C59X.LAN PORT=XXXX NAME=Y [Enter]where XXXX is the adapter’s port address. (To determine theport address, refer to the section “Finding the Adapter’s PortAddress” earlier in this chapter.) The NAME=X and NAME=Yparameters that you assign help distinguish the multipleadapters.If the load sequence is not followed, the system will notoperate correctly. Make sure that the PORT=XXXX parameteris entered for all adapters.