274 Installing theNetWare Server DriverThis chapter describes how to install the NetWare 3.x, 4.x, and 5.x server drivers. To obtainthe latest shipping version of a driver, go to:http://www.3com.com/Installing the Server DriverThe \NWSERVER directory on the EtherCD contains the network driver file (3C90XC.LAN)to be used for servers running NetWare 3.x, 4.x or 5.x.Additional files (NetWare Loadable Modules [NLMs]) that are required for servers runningNetWare are on the EtherCD in the \NWSERVER directory, or they can be obtained from Novell.Obtaining NetWare Loadable ModulesYou can obtain current NLMs for the NetWare servers listed in the table below from theNovell World Wide Web site:http://www.support.novell.comNetWare 3.12To install the driver in a NetWare 3.12 server:1 Copy the MSM31X.NLM, ETHERTSM.NLM, and NBI31.NLM files from the EtherCD tothe directory on your hard drive where other NLM files are located.2 Copy the LAN driver file (3C90XC.LAN) from the EtherCD to the same directory.3 Add the following two lines to the AUTOEXEC.NCF file:load C:\NWSERVER\3C90XC.LAN slot= NAME=FRAME=bind ipx to net=4 Save and exit the file, and then reboot the server.NOTE: The 3Com PCI NICs do not support NetWare 3.xx or 4.xx servers that arenot updated to the latest driver pack.Netware Server NLM NameNetWare 3.12 ETHERTSM.NLMNBI31X.NLMMSM31X.NLMNetWare 4.10, 4.11 ETHERTSM.NLMNBI.NLMMSM.NLMNetWare 5.x ETHERTSM.NLMMSM.NLM
