3Com Baseline 2816 User Manual

Also see for 3CBLUG16A - Baseline Switch 2816: User guide User guide

Contents

3Com Baseline 2816 User Manual Manual pdf 59 page image

C SAFETY INFORMATIONImportant Safety InformationPlease read the following safety information carefullybefore installing the Baseline Switch 2816-SFP/2824-SFPPlus.WARNING: Installation and removal of the unit must becarried out by qualified personnel only.■ If installing the Switch unit in a stack with otherunits, the Switch unit must be installed below thenarrower units and above the deeper units.■ The unit must be connected to an earthed(grounded) outlet to comply with international safetystandards.■ Do not connect the unit to an A.C. outlet (powersupply) without an earth (ground) connection.■ The appliance coupler (the connector to the unit andnot the wall plug) must have a configuration formating with an EN60320/IEC320 appliance inlet.■ The socket outlet must be near to the unit and easilyaccessible. You can only remove power from the unitby disconnecting the power cord from the outlet.■ This unit operates under SELV (Safety Extra LowVoltage) conditions according to IEC 60. Theconditions are only maintained if the equipment towhich it is connected also operates under SELVconditions.France and Peru OnlyThis unit cannot be powered from IT † supplies. If yoursupplies are of IT type, this unit must be powered by230 V (2P+T) via an isolation transformer ratio 1:1, withthe secondary connection point labelled Neutral,connected directly to earth (ground).† Impédance à la terre