Servicing the Network Call Processor Battery 1974 Configure the connection to use the serial port to which you connectedthe cable and to use the settings in Table 38.All messages that associated with the board (for example, theinitialization process) appear in the terminal emulation window.CLI CommandsThe command nbxIpConfig provides a simple way to set the static IPaddress settings required by the NCP and other NBX devices. For anyother purpose, 3Com recommends that you use the command lineinterface only under the direction of an authorized service technician.Servicing theNetwork CallProcessor BatteryIf you lose the system date and time when you reboot an NBX system, itcould mean that the NCP battery must be replaced. The battery is not auser-serviceable item. If you suspect a problem with the battery, contactyour 3Com Technical Support representative.WARNING: There is a danger of explosion if the battery is incorrectlyreplaced. Replace only with the same or equivalent type recommendedby the manufacturer. Dispose of used batteries according to themanufacturer’s instructions.Getting Service andSupportYour authorized 3Com NBX Voice-Authorized Partner can assist you withall of your support needs, including systems and cable plant design,installation, configuration, and project management.A choice of maintenance services, including remote diagnostics, on-sitesupport, telephone technical support, and hardware replacement, isavailable from your 3Com NBX Voice-Authorized Partner. Training andenhancement services are also available.Table 38 Terminal Emulation Program PropertiesProperty ValueEmulation VT100Baud Rate 9600Data bits 8Parity NoneStop bits 1Flow control None
