TELNET Commands B-51show user settingsDisplays the parameters defined for the specified TELNET user. You can use listusers to see which users are defined.show vc settingsDisplays the parameters defined for the specified VC. You can use list vc to seewhich virtual channels are defined.TELNET TELNET commands are available to users who dial in, and whose type is network(type parameter in add user), whose host_type is prompt (host_type parameter inset login user), and whose login_service is TELNET (login_service parameter in setlogin user).telnetEstablishes a TELNET client session with the specified IP host name or address. Inorder for the system to resolve the host name, you must either add the host nameand address to the DNS local host table, or define a DNS server.telnetTCP_port Establishes a TELNET client session with the specified IP host name or addressusing the specified TCP port number. It works just like the TELNET command,except you also specify the TCP port number to be used. The default TCP portnumber is 23.VERIFYverify filterVerifies the syntax of a filter file, which has been previously added to the table. Ifyou update a filter file and TFTP it to the FLASH file system, and the file alreadyexists in the filter table, then you use this command to verify the files syntax. Youcan use list filters to see which files are currently in the filter file table, and whatthe status of each is.TELNETCommands The following commands are available to TELNET users. They are accessed bypressing control - ].close Closes the active TELNET connection.help Lists the available commandssend Transmits a TELNET control character. Be sure the parameters are uppercase. Thechoices are:Parameters DescriptionAYT Are you thereIP Interrupt processBRK BreakAO abort outputEC erase characterEL erase lineGA go aheadNOP no - operation