B-16 A PPENDIX B: CLI COMMAND DESCRIPTIONLISTlist active interfaces Displays the index, name, operational status, and administration status of all activeinterfaces. The output is the same as the list interfaces command, exceptnon-active interfaces are not displayed. Inactive interfaces are interfaces with nocurrent connections.list bridge forwarding Displays the forwarding and filtering information MAC address - A unicast MAC address for which the bridge has forwardingand/or filtering data Status - One of: other - not one of the following invalid - aged out learned - learned, and in use self - statically defined, and in use mgmt - unknown, but filtering information exists RxPkt - Number of packets received from this MAC station RxOctets - No. of bytes (octets) received from this MAC station Fltr - Number of packets received from this MAC station that were filteredout (discarded) Fwd - Number of packets received from this MAC station that wereforwarded TxPkt - Number of packets forwarded to this MAC station TxOctets - Number of bytes forwarded to this MAC stationlist call events Displays the last twenty call events. This is useful when trying to determine why acall over the WAN is not being established. The table displays the system, the uptime, and the event.list call log Displays the current call status for all VCs for which a call has been attemped.Each entry will include the VC name, the current call state (Disconnected,Connecting, or Connected), and the reason why the last call was cleared. Reasonsfor clearing include: line down, PPP timeout, Authentication error, Networkconfiguration error, and termination initiated from either the local or remote side.list critical events Displays the last ten critical status events, and the system time when eachoccurred. You can change which events are logged as critical, using the set facilitycommand. The table displays the system, the up time, and the event.list dns hosts Displays the DNS Local Host name and its IP address, which you configured usingthe add dns host.list dns servers Displays DNS Name Servers, which you configured using the add dns servercommand. The domain name and the server address are listed for each DNSserver.
