FCC Part 68 Statement xiiiSUPPLEMENTARY REGULATORYINFORMATIONThis section describes the compliance of the SuperStack ® II PathBuilder ™ S330 andthe SuperStack II PathBuilder S310 WAN access switches (PathBuilder S330/S310switches) with FCC, Industry Canada, and CE regulations.FCC Part 68 Statement This equipment complies with Part 68 of the Federal CommunicationsCommission (FCC) rules. On the product is a label that contains the FCCregistration number for this device. If requested, you must provide this informationto the telephone company.This equipment is designed to be connected to the telephone network or premiseswiring using a compatible modular jack which is Part 68 compliant. Seeinstallation instructions for details.If this device causes harm to the telephone network, the telephone company willnotify you in advance that temporary discontinuance of service may be required.The telephone company may request that you disconnect the equipment until theproblem is resolved. The telephone company may make changes in its facilities,equipment, operations, or procedures that could affect the operation of thisequipment. If this happens, the telephone company will provide advance notice inorder for you to make necessary modifications to maintain uninterrupted service.If you experience trouble with this equipment or for repair or warrantyinformation, please follow the applicable procedures explained in the TechnicalSupport section of this manual (Appendix A).Canadian CS-03Approval InformationThe Industry Canada label identifies certified equipment. This certification meansthat the equipment meets certain telecommunications network protective,operational, and safety requirements. Industry Canada does not guarantee theequipment will operate to your satisfaction.Before installing this equipment, you should ensure that it is permissible to beconnected to the facilities of the local telecommunications company. You mustalso install the equipment using an acceptable method of connection. In somecases, the inside wiring associated with a single line individual service may beextended by means of a certified connector assembly. You should be aware thatcompliance with the above conditions may not prevent degradation of service insome situations.Repairs to certified equipment should be made by an authorized Canadianmaintenance facility designated by the supplier. Any repairs or alterations youmake to this equipment, or equipment malfunctions, may give thetelecommunications company cause to request that you disconnect theequipment.
