126 3Com VCX V7111 VoIP SIP Gateways User Manual5 Click OK; the HyperTerminal main screen opens.After applying power or resetting the Gateway, the following information is printed on theterminal screen shown in Figure 59.Figure 59 Status and Error MessagesMAC address = 00-90-8F-01-00-9ELocal IP address = 10.1.37.6Subnet mask = 255.255.0.0Default gateway IP address = 10.1.1.5TFTP server IP address = 10.1.1.167Boot file name = ram35136.cmpINI file name = mp108.iniCall agent IP address = 10.1.1.18Log server IP address = 0.0.0.0Full/Half Duplex state = HALF DUPLEXFlash Software Burning state = OFFSerial Debug Mode = OFFLan Debug Mode = OFFBootLoad Version 1.75Starting TFTP download ... Done.MP108 Version 3.80.00SysLog SupportOverviewSysLog protocol is an event notification protocol that allows a machine to send eventnotification messages across IP networks to event message collectors - also known asSysLog servers. The SysLog protocol is defined in RFC 3164 IETF standard.Since each process, application, and operating system was written somewhat independently,there is little uniformity to SysLog messages. For this reason, no assumption is made on thecontents of the messages other than the minimum requirements of its priority.SysLog uses UDP as its underlying transport layer mechanism. The UDP port that has beenassigned to SysLog is 514.The SysLog message is transmitted as an ASCII message. The message starts with aleading < (less-than character), followed by a number, which is followed by a > (greater-thancharacter). This is optionally followed by a single ASCII space.The number with these brackets is known as the Priority and represents both the Facility andSeverity. The Priority number consists of one, two, or three decimal integers.Example<37> Oct 11 16:00:15 mymachine su: 'su root' failed for lonvick on/dev/pts/8
