3Com VCX v7111 Installation Manual

Also see for VCX V7111: Product guide User manual User manual User guide Installation guide

Contents

3Com VCX v7111 Installation Manual Manual pdf 39 page image

3Com VCX V7111 Fast Track Installation Guide 399 Click the Reset button and click OK in the prompt; The VCX V7111 applies the changesand restarts. This takes approximately 2 minutes to complete. When the VCX V7111 hasfinished restarting, the Ready and LAN LEDs on the front panel are lit green.SIP users should continue with “Example of Connecting Two 8FXS Devices”.Example of Connecting Two 8FXS DevicesThis example applies to H.323 and SIP. Figure 20 on page 40 shows an example of twoVCX V7111 8FXS devices’ internal routing tables. Phone 2001 is connected to the firstchannel of gateway 10.2.222.108, and phone 2101 is connected to the first channel ofgateway 10.2.222.107.To make a call between two gateways, lift the receiver of phone 2001; you hear a dial toneand the first channel’s LED lights up. Dial 2101; after dialing the last digit, the data LEDbegins blinking (indicating traffic) and phone 2101 rings.The prefixes you choose in the ‘Tel to IP Routing’ table must differentiate themedia gateways from each other to ensure correct routing. In the example, usingthe first digit (2) doesn’t differentiate the devices, thus 2 digits of the phone numberare used.To enable phones connected to the same VCX V7111 to communicate with eachother, define in the internal routing table the IP address and corresponding phonenumbers of the device itself (applicable only to H.323 devices).