9Adjusting the projector's elevatorWhen the place to put the projector is slightly uneven to the left or right, use theelevator feet to place the projector horizontally.Using the feet can also tilt the projector in order to project ata suitable angle to the screen, elevating the front side of theprojector within 8 degrees.This projector has 2 elevator feet and 2 elevator knobs. An elevator foot isadjustable while pulling up the elevator knob on the same side as it.1. Holding the projector, pull the elevator knobs up to loose the elevator feet.2. Position the front side of the projector to the desired height.3. Release the elevator knobs in order to lock the elevator feet.4. After making sure that the elevator feet are locked, put the projector gently.5. If necessary, the elevator feet can be manually twisted to make more preciseadjustments. Hold the projector when twisting the feet.Setting upTo loose an elevator foot,pull up the elevator knobon the same side as it.CAUTION Ź'RQRWKDQGOHWKHHOHYDWRUNQREVZLWKRXWKROGLQJWKHSURMHFWRUsince the projector may drop down.Ź'RQRWWLOWWKHSURMHFWRURWKHUWKDQLWHOHYDWLQJLWVIURQWZLWKLQGHJUHHVXVLQJthe adjuster feet. A tilt of the projector exceeding the restriction could causemalfunction or shortening the lifetime of consumables, or the projector itself.Using the security bar and slotA commercial anti-theft chain or wire up to 10 mm indiameter can be attached to the security bar on theprojector.Also this product has the security slot for the Kensingtonlock.For details, see the manual of the security tool.CAUTION Ź'RQRWXVHWKHVHFXULW\EDUDQGWKHsecurity slot to prevent the projector from falling down,since it is not designed for it.NOTE • The security bar and the security slot are notcomprehensive theft prevention measures. They are intendedto be used as supplemental theft prevention measure.7R¿QHO\DGMXVWWZLVWthe foot.qSecurity slotAnti-theft chain or wireSecurity bar3M™ Digital Projector X90© 3M 2007. All Rights Reserved.