Setting Unit Policieswww.3ware.com 1456 Tab to the OK button and press Enter to select it.You return to the main 3BM screen.7 When you are finished making changes, press F8 to save them and exit3BM.Setting Auto-Verify for a UnitFor 9000-series controllers, the auto-verify policy causes verify tasks to beperformed automatically, whenever the controller firmware algorithmsdetermine that a verify task is needed. This feature is designed to makeverification of units easier. When you enable this for a unit, the controller willrun verify tasks as they are required.If there is no schedule set up for verify tasks, then the controller firmware caninitiate a verify task at any time. If a verify time window is scheduled, thenthe controller will not start a verify task for that unit outside the time window,and may or may not start a verify task for that unit within the time window,depending on whether one is needed.If Auto-verify is not set and there is no schedule for verify tasks, you mustmanually specify when you want to run a verify, on the 3DM Managementpage. If a schedule is set for verify, then the verify that you manually start willonly run during the scheduled time.You can set this policy while creating a unit through 3DM or CLI, and youcan change it for existing units.To set the auto-verify policy for an existing unit1 Choose Management > Controller Settings from the menu bar in 3DM.2 In the Unit Policies section of the Controller Settings Page, check theAuto Verify box for the unit for which you want to set it. (To disable thispolicy, uncheck the box.)The page refreshes, and a message at the top confirms the change youhave made (Figure 63).
