Control panel overview 19 Status LEDThe control panel has a status LED that indicates if there are any faults or warningspresent. The table below shows the meaning of the LED indications.For further information on fault and warning indications, see Identifying error andwarning messages (page 51). USB connectorThe USB connector is used for connecting the control panel to a PC. Whenconnected, the control panel acts as an USB adapter for data transfer between thePC tool and the drive. It is also possible to transfer data between the PC and thecontrol panel through the USB connection. RJ-45 connectorThe RJ-45 connector is used to electrically connect the control panel to the drive.Mechanical connection is achieved with the clip on the top. Type code labelThe type code label contains revision information.Green, continuous The drive is functioning normally.Green, flickering Data is transferred between the PC tool and drive through theUSB connection of the control panel.Green, blinking There is an active warning in the drive.Red, continuous There is an active fault in the drive.Blue, blinking Bluetooth interface is enabled.It is in discoverable mode andready for pairing.Blue, flickering Data is transfered through the Bluetooth interface of thecontrol panel.ABB Oy ACS-AP-W SN:A1250121SB CODE: 3AXD500000259643AXD50000025964A1250121SB SW: 5.01 RoHSFCC ID: 2AFNGAPWSERIES IC: 20555-APWSERIESType codeABB OyBar codeBar codein readabletextFCC ID and IC CANADA numbers SW version RoHS markingMRP codeSerial number