ABB ACS150 User Manual
Also see for ACS150 series: User manualUser manualUser manualInstallation instructionsInstallation instructions
                                                                                                                                  | |
Contents
| 
Actual signals and parameters64Parameters and signals in the Short Parameter modeThe parameters and signals used in the Short Parameter mode are displayed on thepanel in the following order.No. Name/Value Description99 START-UP DATA Application macro. Definition of motor set-up data. Def9902 APPLIC MACRO Selects the application macro or activates FlashDrop parameter values. Seechapter Application macros.1 = ABBSTANDARD1 = ABB STANDARD Standard macro for constant speed applications2 = 3-WIRE 3-wire macro for constant speed applications3 = ALTERNATE Alternate macro for start forward and start reverse applications4 = MOTOR POT Motor potentiometer macro for digital signal speed control applications5 = HAND/AUTO Hand/Auto macro to be used when two control devices are connected to thedrive:- Device 1 communicates through the interface defined by external controllocation EXT1.- Device 2 communicates through the interface defined by external controllocation EXT2.EXT1 or EXT2 is active at a time. Switching between EXT1/2 through digitalinput.31 = OEM SET LOAD FlashDrop parameter values as defined by the FlashDrop file.FlashDrop is an optional device. FlashDrop allows fast customisation of theparameter list, e.g. selected parameters can be hidden. For moreinformation, see FlashDrop Userís Manual [3AFE68591074 (English)].9905 MOTOR NOM VOLT Defines the nominal motor voltage. Must be equal to the value on the motorrating plate. The drive cannot supply the motor with a voltage greater thanthe input power voltage.WARNING! Never connect a motor to a drive which is connected to powerline with voltage level higher than the rated motor voltage.200(US: 230)400(US: 460)100...300 V (200 V /US: 230 V units)230...690 V (400 V /US: 460 V units)Voltage.Note: The stress on the motor insulations is always dependent on the drivesupply voltage. This also applies to the case where the motor voltage ratingis lower than the rating of the drive and the supply of the drive.9906 MOTOR NOM CURR Defines the nominal motor current. Must be equal to the value on the motorrating plate.I2N0.2Ö2.0 ∑ I2N Current9907 MOTOR NOM FREQ Defines the nominal motor frequency, i.e the frequency at which the outputvoltage equals the motor nominal voltage:Field weakening point = Nom. frequency ∑ Supply voltage / Mot nom. voltageEur: 50 /US: 6010.0Ö500.0 Hz FrequencyOutput voltageOutput frequency99079905 |
Related manuals for ABB ACS150 series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine