ABB ACS560 Hardware Manual

Also see for ACS560: User manual Quick installation and start-up guide Quick installation and start-up guide Quick installation and start-up guide Quick installation and start-up guide

Contents

ABB ACS560 Hardware Manual Manual pdf 61 page image

Electrical installationContents of this chapterThe chapter describes how to check the insulation of the assembly and the compatibilitywith IT (ungrounded) and corner-grounded TN systems. It then shows how to connect thepower and control cables, install optional modules and connect a PC.WarningsWARNING!Obey the instructions in chapter Safety instructions (page 11). If you ignore them,injury or death, or damage to the equipment can occur.Make sure that the drive is disconnected from the input power duringinstallation. If the drive is already connected to the input power, wait for 5minutes after disconnecting the input power.Required toolsTo perform the electrical installation, you need the following tools:• wire stripper• screwdriver and/or wrench with a set of suitable bits.Checking the insulation of the assembly￭ DriveDo not make any voltage tolerance or insulation resistance tests on any part of the drive.Voltage tolerance or insurance resistance tests can result in damage of the drive. Everydrive has been tested for insulation between the main circuit and the chassis at the factory.6Electrical installation 61