Technical data131MaterialsCabinet Hot-dip zinc coated 1.5 mm thick steel sheet (thickness of coating approximately 20micrometres). Polyester thermosetting powder coating (thickness approximately 80micrometres) on visible surfaces. Colour RAL 7035 light beige semigloss.Busbars Tin-plated copperFire safety of materials(IEC 60332-1)Insulating materials and non-metallic items mostly self-extinctivePackage Wood. Plastic covering of the package: PE-LD, bands PP or steel.Disposal The drive contains raw materials that should be recycled to preserve energy and naturalresources. The package materials are environmentally compatible and recyclable. Allmetal parts can be recycled. The plastic parts can either be recycled or burned undercontrolled circumstances, according to local regulations. Most recyclable parts are markedwith recycling marks.If recycling is not feasible, all parts excluding electrolytic capacitors and printed circuitboards can be landfilled. The DC capacitors (C1-1 to C1-x) contain electrolyte and theprinted circuit boards contain lead, both of which are classified as hazardous waste withinthe EU. They must be removed and handled according to local regulations.For further information on environmental aspects and more detailed recycling instructions,please contact your local ABB distributor.Applicable standardsThe drive complies with the standards below. The compliance with the European LowVoltage Directive is verified according to standards EN 61800-5-1 and EN 60204-1.• IEC/EN 61800-5-1:2007 Adjustable speed electrical power drive systems. Part 5-1: Safety requirements –electrical, thermal and energy• EN 60204-1:2006 +A1:2009Safety of machinery. Electrical equipment of machines. Part 1: General requirements.Provisions for compliance: The final assembler of the machine is responsible for installingemergency-stop device.• EN 60529:1991 Degrees of protection provided by enclosures (IP code)• IEC 60664-1:2007 Insulation coordination for equipment within low-voltage systems. Part 1: Principles,requirements and tests.• EN 61800-3:2004 Adjustable speed electrical power drive systems. Part 3: EMC requirements and specifictest methods• UL 508C (2002) UL Standard for Safety, Power Conversion Equipment, second edition• UL 508A (2001) UL Standard for Industrial Control Panels, first edition• NEMA 250 (2003) Enclosures for Electrical Equipment (1000 Volts Maximum)• CSA C22.2 No. 14-10:2010 Industrial control equipment
