Technical data 193Applicable standardsCE markingA CE mark is attached to the drive to verify that the drive complies with the provisions ofthe European Low Voltage and EMC Directives. The CE marking also verifies that thedrive, in regard to its safety functions (such as Safe torque off), conforms with theMachinery Directive as a safety component. Compliance with the European Low Voltage DirectiveThe compliance with the European Low Voltage Directive has been verified according tostandard EN 61800-5-1. Compliance with the European EMC DirectiveThe EMC Directive defines the requirements for immunity and emissions of electricalequipment used within the European Union. The EMC product standard (EN 61800-3:2004) covers requirements stated for drives. See section Compliance with EN 61800-3:2004 below. Compliance with the European Machinery DirectiveThe drive is an electronic product which is covered by the European Low VoltageDirective. However, the drive includes the Safe torque off function and can be equippedwith other safety functions for machinery which, as safety components, are in the scope ofStandard InformationEuropean electrical safety requirements product standardsIEC/EN 61800-5-1:2007 Adjustable speed electrical power drive systems. Part 5-1: Safetyrequirements – electrical, thermal and energyIEC 60146-1-1:2009EN 60146-1-1:2010Semiconductor converters – General requirements and line commutatedconverters – Part 1-1: Specification of basic requirementsIEC/EN 60664-1:2007 Insulation coordination for equipment within low-voltage systems. Part 1:Principles, requirements and testsIEC 60529:1989EN 60529:1991Degrees of protection provided by enclosures (IP code).IEC 60204-1:2005 + A1:2008EN 60204-1:2006 + AC:2010Safety of machinery. Electrical equipment of machines. Part 1: Generalrequirements.IEC/EN 61439-1:2009 Low-voltage switchgear and controlgear assemblies -- Part 1: GeneralrulesEMC performanceIEC/EN 61800-3:2004 Adjustable speed electrical power drive systems. Part 3: EMCrequirements and specific test methodsProduct requirements in North AmericaUL 508A 1st edition:2001 Industrial Control PanelsUL 50 12th edition:2007 Enclosures for Electrical Equipment, Non-Environmental ConsiderationsCSA C22.2 No. 14-13:2013 Industrial control equipmentCSA C22.2 No. 274-13:2013 Adjustable speed drives
