Parameters and firmware blocks178Group 33 SUPERVISIONConfiguration of signal supervision.33Firmware block:SUPERVISION(17)Block outputs located in otherparameter groups6.14 SUPERV STATUS (page 112)33.01 SUPERV1 FUNC FW block: SUPERVISION (see above)Selects the mode of supervision 1.(0) Disabled Supervision 1 not in use.(1) Low When the signal selected by parameter 33.02 SUPERV1 ACT fallsbelow the value of parameter 33.04 SUPERV1 LIM LO, bit 0 of 6.14SUPERV STATUS is activated. To clear the bit, the signal mustexceed the value of parameter 33.03 SUPERV1 LIM HI.(2) High When the signal selected by parameter 33.02 SUPERV1 ACTexceeds the value of parameter 33.03 SUPERV1 LIM HI, bit 0 of 6.14SUPERV STATUS is activated. To clear the bit, the signal must fallbelow the value of parameter 33.04 SUPERV1 LIM LO.(3) Abs Low When the absolute value of the signal selected by parameter 33.02SUPERV1 ACT falls below the value of parameter 33.04 SUPERV1LIM LO, bit 0 of 6.14 SUPERV STATUS is activated. To clear the bit,the absolute value of the signal must exceed the value of parameter33.03 SUPERV1 LIM HI.(4) Abs High When the absolute value of the signal selected by parameter 33.02SUPERV1 ACT exceeds the value of parameter 33.03 SUPERV1 LIMHI, bit 0 of 6.14 SUPERV STATUS is activated. To clear the bit, theabsolute value of the signal must fall below the value of parameter33.04 SUPERV1 LIM LO.33.02 SUPERV1 ACT FW block: SUPERVISION (see above)Selects the signal to be monitored by supervision 1. See parameter 33.01 SUPERV1 FUNC.Value pointer: Group and indexSUPERVISION 45TLF11 10 msec (6)33.01 SUPERV1 FUNC[ Disabled ]< 33.02 SUPERV1 ACT[ SPEED ACT ](7 / 1.01)33.03 SUPERV1 LIM HI[ 0.00 ]33.04 SUPERV1 LIM LO[ 0.00 ]33.05 SUPERV2 FUNC[ Disabled ]< 33.06 SUPERV2 ACT[ CURRENT ](1 / 1.04)33.07 SUPERV2 LIM HI[ 0.00 ]33.08 SUPERV2 LIM LO[ 0.00 ]33.09 SUPERV3 FUNC[ Disabled ]< 33.10 SUPERV3 ACT[ TORQUE ](1 / 1.06)33.11 SUPERV3 LIM HI[ 0.00 ]33.12 SUPERV3 LIM LO[ 0.00 ]6.14 SUPERV STATUS
