Startup behaviour3611SVC 440 795 M1100Terminal modeThe display system is provided with TERMINAL mode. Thismode enables the display and the keypad of the displaysystem to be used as a terminal for operating another device.In this operating mode you are thus able to remotely controlall devices supporting Terminal mode operation. Theinterface to the other device can be implemented using theserial interface or CL-NET.Permanent TERMINAL mode settingIn the SYSTEM menu you set the display system to start inTERMINAL mode when the power supply is switched on.X Switch to the System menu.Activating an automatic startup in TERMINAL modeRequirement: The display system is in RUN or STOP modewithout visualization (the System menu must be reachable).X Select TERMINAL mode in the System menu and press OK.X The next time that the display system is started, it willestablish the connection to the selected device.X Press ESC to return to the status display.Deactivating an automatic startup in TERMINAL modeX Select TERMINAL MODE å and press OK.The automatic starting in TERMINAL mode has beendeactivated.h TERMINAL mode operation is only possible if the displaysystem is in STOP mode.h If the display system is password-protected, the Systemmenu can only be accessed after the display system hasfirst been “unlocked” (a section “Unlocking the displaysystem”, from page 347).P BUTTONS ÆRUN MODECARD MODETERMINAL MODE å æh The correct station number must be selected in order forthe display system to start TERMINAL mode with thecorrect station (a chapter “Commissioning”, page 79).P BUTTONS ÆRUN MODECARD MODETERMINAL MODE æ
