• the character ^ in front of an input/output signal name indicates that the signalname may be customized using the PCM600 software.• the character * after an input signal name indicates that the signal must beconnected to another function block in the application configuration to achievea valid application configuration.• Logic diagrams describe the signal logic inside the function block and are borderedby dashed lines.• Signals in frames with a shaded area on their right hand side represent settingparameter signals that are only settable via the PST or LHMI.• If an internal signal path cannot be drawn with a continuous line, the suffix -intis added to the signal name to indicate where the signal starts and continues.• Signal paths that extend beyond the logic diagram and continue in anotherdiagram have the suffix ”-cont.”• Dimensions are provided both in inches and mm. If it is not specifically mentionedthen the dimension is in mm.1.5 IEC61850 edition 1 / edition 2 mappingTable 1:IEC61850 edition 1 / edition 2 mappingFunction block name Edition 1 logical nodes Edition 2 logical nodesAEGPVOC AEGGAPC AEGPVOCAGSAL AGSALSECLLN0AGSALALMCALH ALMCALH ALMCALHALTIM ALTIMALTMS ALTMSALTRK ALTRKBCZSPDIF BCZSPDIF BCZSPDIFBCZTPDIF BCZTPDIF BCZTPDIFBDCGAPC SWSGGIO BBCSWIBDCGAPCBRCPTOC BRCPTOC BRCPTOCBRPTOC BRPTOC BRPTOCBTIGAPC B16IFCVI BTIGAPCBUSPTRC_B1 BUSPTRCBBSPLLN0BUSPTRCBUSPTRC_B2 BUSPTRC BUSPTRCBUSPTRC_B3 BUSPTRC BUSPTRCTable continues on next pageSection 1 1MRK 505 337-UUS -Introduction22Application manual
