(status) of the result of the commands is supposed to be achieved by other means, such asbinary inputs and SPGGIO function blocks.PSTO is the universal operator place selector for all control functions.Even if PSTO can be configured to allow LOCAL or ALL operatorpositions, the only functional position usable with the SPC8GAPCfunction block is REMOTE.12.8.3 Setting guidelinesThe parameters for the single point generic control 8 signals (SPC8GAPC) function areset via the local HMI or PCM600.Operation: turning the function operation Enabled/Disabled.There are two settings for every command output (totally 8):Latchedx: decides if the command signal for output x is Latched (steady) or Pulsed.tPulsex: if Latchedx is set to Pulsed, then tPulsex will set the length of the pulse (inseconds).12.9 AutomationBits, command function for DNP3.0AUTOBITS12.9.1 IdentificationFunction description IEC 61850identificationIEC 60617identificationANSI/IEEE C37.2device numberAutomationBits, command function forDNP3 AUTOBITS - -12.9.2 ApplicationAutomation bits, command function for DNP3 (AUTOBITS) is used within PCM600 inorder to get into the configuration the commands coming through the DNP3.0protocol.The AUTOBITS function plays the same role as functions GOOSEBINRCV (forIEC 61850) and MULTICMDRCV (for LON).AUTOBITS function block have 32individual outputs which each can be mapped as a Binary Output point in DNP3. The1MRK 505 337-UUS - Section 12Control379Application manual
