ABB REB670 Operator's Manual
Also see for RELION REB670: Product guideInstallation manualTechnical reference manualInstallation manualProduct guide
                                                                                                                    | |
Contents
| 
Main menu/Settings/General settings/Communication/Ethernet configuration/Rear OEM - Redundant PRPRedundant station bus communication IEC61850-8-1 are set here.Main menu/Settings/General settings/Communication/Ethernet configuration/GatewayIf a gateway is used to access the system the address to that gateway is entered here.9.2.3 Analog and I/O modules9.2.3.1 OverviewUnder Analog modules in the General settings menu there are settings for Analoginputs and I/O modules. Within each instance of analog input there are settings forall 12 channels that include the name of the channel, star point of the CT circuit,the primary and secondary values from the measuring transformers (CTs). Thechannel type and ratings are shown but cannot be changed.The settings for binary inputs and outputs even include the milliampere inputmodules. A mix of up to 14 instances of BIM, BOM and IOM is possibledepending on the physical configuration of the IED. Operation ON or OFF can beset for all of these and for the BIMs oscillation release and oscillation blocksettings are available. These settings are on board level and apply to all binaryinputs or outputs on a board.9.2.3.2 Analog modulesMain menu/Settings/General Settings/Analog modules/AnalogInputsDisplays all configurations of analog current input modules with parameters. Eachchannel has parameters where the type of channel is set, the primary and secondaryvalues from CTs and for Current Transformers the star point location (line side orbusbar side) is set.Main menu/Settings/General Settings/Analog modules/MergingUnitDisplays parameters for the merging units. For the MU channels, no primary orsecondary values need to be set, due to the fixed standardized scaling of 1 mA/10mV per LSBMain menu/Settings/General Settings/Analog modules/3PhaseAnalogGroup/SMAIX:YHere, settings for the Fourier filters, the minimum system voltage required tomeasure frequency, the item designation of CTs are set. These settings are requiredby the preprocessing blocks and are usually only adjusted during the initialengineering phase.1MRK505209-UEN E Section 9Read and change settings47Operator's manual |
Related manuals for ABB RELION REB670
ABB REG670 Operator's Manual
ABB RET670 Operator's Manual
ABB RET 670 Operator's Manual
ABB REA 105 Operator's Manual
ABB PR512 Operator's Manual
ABB REB500 Operation Manual
ABB REL 511-C1 2.5 Series Operator's Manual
ABB Relion 670 series Operation Manual
ABB RELION REB500 Operation Manual
ABB REB670 Product Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine