ABH 6600EO Series Installation Manual

ABH 6600EO Series Installation Manual Manual pdf 1 page image

ISSUED 03-28-196600EO-1-03.DWGCOVERLOCKING THUMB TURN (If used)#8 x 1/2" FHSMSTRIM PLATEMORTISE LOCK8-32 x 1/4" FHMS12-24 x 3/4" FH COMBO10-32 x 1-3/4" FHMS8-32 x 3/8" FHMS10-32 x 1/4" PAN HD. M.S.PUSH OR PULL HANDLE ASSYEXIT ONLY PLATEADAPTER PLATE8 141213111051415 2161415131211221109 4122256713441ITEM1QTY1PART DESCRIPTIONINSTALLATION INSTRUCTIONS:1. Install mortise lock (item 10) using (2) 12-24 screws (item 12). Then mount the trim plate (item 11) using (2) 8-32 screws (item 13).2. Before mounting adapter plate (item 6) & exit only plate (item 8), determine which side of the door will receive the push or pull handleassembly (item 4) and the direction the handle will mount. Handle can be mounted up, down or horizontally.3. Mount adapter plate (item 6) & exit only plate (item 8) to door with (2) 10-32 screws (item 5) thru door and mortise lock to (2) 10-32 sexbolts (item 7). tighten securely.4. Before mounting handle assembly (item 4), cam pin must be rotated towards the correct side of the handle (see detail A).5. Mount handle assembly (item 4) to adapter plate (item 6) with (4) 10-32 screws (item 3) with (4) star washers (item 9).6. Test lock for proper operation. If latch bolt does not extend or retract freely because of any type of binding, loosen mounting screws toadjust alignment of trim handle assembly (item 4) and re-tighten screws one at a time while checking latch bolt movement.7. Place cover (item 1) over handle assembly (item 4) and secure with (2) 8-32 screws (item 2) on each side.8. If provided, install locking thumb turn (item 14) using (2) #8 screws (item 15).PATENT No. 6,196,599 & 5,730,4782 319#10 STAR WASHER6600EOPAGE 1 OF 3NOTES1. TRIM CAN BE MOUNTED UP, DOWN, HORIZONTALLY OR VERTICALLY.2. VISION LITE MUST BE AT LEAST 6" FROM CENTERLINE OF TRIM.3. USES 6600EO SERIES MORTISE LOCK DOOR PREP.4. 6600EO MORTISE LOCK CYLINDER & LOCK CAM NOT PROVIDED.**SQUARE-OR-ROUNDCOVERNOTE:BEFORE MOUNTING BASE ASSEMBLIESCAM PIN MUST BE ROTATED TOWARDSSIDE INDICATED BY ARROW STAMPEDON THE BASE.HINGE SIDE)HANDLEHORIZONTAL(MUST POINTDOWNHANDLEUPHANDLE**EDGE GUARD NOTE:WHEN PREPPING THE DOOR,DETERMINE IF THE DOOR WILLRECEIVE AN EDGE GUARD, IF SO,THE EDGE GUARD SHOULD BEINSTALLED FIRST AND THEN THEPREP FOR THE MORTISE LOCKSHOULD BE MEASURED FROM THEOUTSIDE EDGE OF THE EDGEGUARD.DETAIL "A"CAM SHAFT6600EO SERIES EXIT ONLY PUSH/PULLHANDLE INSTALLATION FOR MORTISE LOCKPUSH SIDEORPULL SIDE8712-24 x 1/2" SEX BOLT2PUSH SIDESHOWNFOREXAMPLEULISTEDLC R USc

/ 3

Related manuals for ABH 6600EO Series