ABH LR6000 Series Installation Instructions Manual

ABH LR6000 Series Installation Instructions Manual Manual pdf 1 page image

RO www.abhmfg.comE-mail: abhinfo@abhmfg.comArchitectural Builders Hardware Mfg., Inc.1222 Ardmore Ave., Itasca, IL 60143630.875.9900; FAX 800.9FAXABH (932.9224) c 2014 ABH Mfg., Inc.printed in USAINSTALLATION INSTRUCTIONS1. Prep door according to LR6000 Series latch template.2. Install latch using either #8 wood screws or 8-32 machine screws (Item 2).3. Check (1) base assembly (Item 3) to ensure the cam is the position shown in Detail “A” (see above).Place the base assembly on push side of door by inserting the cam shaft into the latch cam asdetailed above.4. Check the other base assembly (Item 3) and ensure the cam is the position shown in Detail “A” (seeabove). Place base assembly on pull side of door by engaging the shaft into the latch cam asdetailed above. Fasten both base assemblies together with (4) 10-32 screws (Item 4) and (4) 10-32hex nuts (Item 5). Test that cams rotates freely on both sides of the door after tightening thescrews.5. Install the push handle assembly (Item 7) to the base assembly installed on push side of door using(2) socket head cap screws (Item 8). Insert (1) stop pin (Item 9) through the push base assembly onthe same side of the direction the push handle assembly is pointing. Test push handle for properoperation to be sure stop pin was installed in appropriate base assembly hole.6. Repeat above Step #5 on the pull side of the door for the pull handle assembly (Item 6). Insert (1)stop pin (Item 9) through the pull base assembly on the opposite side of the direction the pullhandle assembly is pointing. Test pull handle for proper operation to be sure stop pin wasinstalled in appropriate base assembly hole.7. Place covers (Item 10) over handles and fasten each cover with (2) 8-32 screws (Item 11).PARTS LISTDESCRIPTIONQTYITEMLATCH11#8 X 3/4" FHWS OR 8-32 X 3/8 FHMS UC22BASE ASSEMBLY2310-32 X 2-1/2 PHMS4410-32 HEX NUT45HANDLE ASSEMBLY, PULL16HANDLE ASSEMBLY, PUSH176-32 X 3/8" SHCS48STOP PIN29COVER2108-32 X 3/8" OVAL HEAD M.S.411LR6000 SERIESINSTALLATION FOR CYLINDRICAL LATCH1011218118EDGE GUARD NOTE:WHEN PREPPING THE DOORFOR THE BACKSET,DETERMINE IF THE DOORWILL RECEIVE AN EDGEGUARD. IF SO, THE EDGEGUARD SHOULD BEINSTALLED FIRST ANDTHEN THE PREP FOR THELATCH BACKSET SHOULDBE MEASURED FROM THEOUTSIDE EDGE OF THEEDGE GUARD.NOTES:1. TRIM CAN BE MOUNTED UP or DOWN2. USES STANDARD 161 DOOR PREP.3. VISION LITE MUST BE AT LEAST 6" FROM LATCH PREP.4. MAKE (4) THROUGH HOLES IN DOOR AS PER TEMPLATEALL PREP MOUNTING HOLESTO BE STRAIGHT & PARALLELTO ONE ANOTHER. THIS WILLHELP PREVENT ANY BINDINGOF MECHANICAL PARTS.1069800-02.IDWLR6000ISSUED 06-30-14735469391111CAMSHAFT88NOTE:BEFORE MOUNTINGBASE ASSEMBLIES,CAMS MUST BEROTATED AS PERDRAWING SHOWNON RIGHT, INDETAIL "A".DETAIL "A"CAM SHAFTLATCH CAM

/ 3

Related manuals for ABH LR6000 Series