66PP-32KOOLMASTER PP-32 REV.015.14.4 Sensor Assignment5.14.4.1 Assigning Sensors to the Room T° and Fan StagesThe controller uses the average reading of activated sensors to calculatethe room temperature. Fan stages use this temperature to operate.The selection of sensors that are used to determine the average roomtemperature differs depending on the selected program. Therefore, theuser must make a separate sensor assignment for each program in use.Note also that sensor assignment can only be done from the installermode (see sec. 5.14.2).Set the function to "17.FanSettings" from the main menuusing the navigation buttons. Notethat this menu is only available inthe installer mode (see sec. 5.14.2).Press the down-arrow key once toselect "2.Sensors" menu then pressthe right-arrow key.Press the right-arrow key once toselect "1.Program (x)" or "1.SensorSelection" menu (depending if manyprograms are activated). Sensorsthat have been activated during theinstallation are displayed (see sec. 5.14.3).Use the right and left-arrow keys to select the desired sensor. Whenthe item is flashing, press to activate the sensor or todeactivate it. The selected sensors are used to calculate the aver-age room temperature into the selected program.Proceed in similar fashion to activate the proper sensors for eachprogram. Refer to sec. 5.2 to select another program. + 2 P 222 2@A2 IPQRSTUV√√√ 2 I 2222@AP 222e5 + (2I
