ACP RC22S2 Quick Start & Reference Manual

Also see for RC22S2: Service manual Quick start guide

ACP RC22S2 Quick Start & Reference Manual Manual pdf 1 page image

Manual OperationTo cook food using a specific entered time and power level.1. Open oven door and place food in oven. Close door.2. Press TIME ENTRY pad and enter cooking time.3. Press POWER LEVEL pad to change power level if desired.• For a lower microwave power, press pads 1 (for 10%) through 9 (for90%).4. If stage cooking is desired, press STAGE pad and repeat steps 2 through 4.5. Press START pad.6. At end of cooking cycle oven beeps and shuts off.DONE displays.Programming Pads1. READY must be in the display. If not, open and close door.2. Press PROGRAM SAVE pad.• Programming mode begins.• Enter Program to Add/Review: displays.3. Press pad to be programmed or reprogrammed.• Display will change to review all settings for the pad.• The pad number that is being programmed displays beside the wordITEM.4. Press TIME ENTRY to program amount of cooking time.• Enter desired cooking time by using numeric key pads.• Maximum cooking time is 60 minutes.5. Press POWER LEVEL to program level of microwave power.• Press numeric key pad for desired level. Press numeric key pad againto set power level to 100%.• For a lower microwave power, press pads 1 (for 10%) through 9 (for90%).6. Press Quantity pad if different cooking factor is desired.• Default of CF:80 displays.• Enter desired cooking factor by using numeric key pads (1 for 10%through 0 for 100%).7. Press PROGRAM SAVE to save the program changes.8. To discard changes, press STOP/RESET.Mid-Cycle PauseTo add a pause to a programmedcooking cycle:1. Press HIDDEN PAD afterentering time or power level.2. A short beep sounds. Thisindicates the program is set for amid-cycle pause.3. Continue programming pad asdesired.When programmed pad is used,pause will occur in the middle of totalprogrammed time. Oven will beepcontinuously and Program Pauseddisplays until door is open and shut.To continue cycle, press START pad.CLEAN FILTERThis oven displays CLEAN FILTERat user defined intervals. When themessage displays ACP recommendscleaning the air filter thoroughly.Cleaning the air filter will not shutoff the message. The message willstop displaying automatically after24 hours. Depending on microwaveuse and environmental conditions,the filter may need to be cleanedmore frequently. Once the frequencyis determined, set the option for theappropriate time frame.So...how do I use it?PreprogrammedPadsTo cook food usingpreprogrammed cookingsequences.1. Open oven door and place foodin oven. Close door.• To add additional servingspress QUANTITY pad.• Up to eight quantities can beadded.2. Press desired pad.3. Oven begins to cook.4. At end of cooking cycle ovenbeeps and shuts off. DONEdisplays.Oven ClearancesA—For North American (UL/CSA) models, allow atleast 2” (5.1 cm) of clearance around top of oven.For International (50 Hz) models, allow at least 7”(17.8 cm) of clearance around top of oven. Proper airflow around oven cools electrical components. Withrestricted air flow, oven may not operate properly andlife of electrical parts is reduced.B—Allow at least 2 9 /16” (6.5 cm) between airdischarge on back of oven and back wall.C—Allow at least 2” (5.1 cm) around sides of oven.Refer to Product Safety Manual for Safety StatementsComplete Owner’s Manual available onlineQuick Start Reference GuideQuantity Time Entry Power Level Stage Program Save