ACP ACE series Quick Start & Reference Manual

Also see for ACE series: Owner's manual

Contents

ACP ACE series Quick Start & Reference Manual Manual pdf 1 page image

Quick Start Reference GuideRefer to Product Safety Manual for Safety StatementsComplete Owner’s Manual available onlineManual OperationTo cook food using a specific entered time and power level.1. Press Preheat On/Off pad to start the oven.• Oven Preheating 475°F displays with Oven Preheating flashing.2. Oven reaches preheat temperature.• Ready 475°F displays.3. Place food in the oven.4. Press Time Entry pad.• Enter desired cooking time by using numeric keypad.5. Press Temp Entry pad if cooking temperature differs from preheat temperature.• Enter the new temperature.6. Press Power Level pad.• For a lower microwave power, press pads 1 (for 10%) through 9 (for 90%).0 turns off the microwave power and cooking is by convection only.• Press any numeric key pad twice to set power level to 100%.7. If stage cooking is desired, press STAGE pad and repeat steps 4, 5, and 6.• Up to 4 different stages can be programmed.8. Press the Start pad to begin the cooking cycle.Programming Items1. Oven must be ON.• Press Preheat On/Off.• Oven Preheating 475°F displays with Oven Preheating flashing.2. Oven reaches preheat temperature.• Ready 475°F displays with Ready flashing.3. Press Program Save pad.4. Press pad to be programmed or reprogrammed.5. Press Time Entry pad to program amount of cooking time.• The total microwave cooking time (all stages combined) is 20 minutes.6. Press Temp Entry pad to program the cooking temperature.• Enter desired temperature by using numeric pads.7. Press Power Level pad to program level of microwave power.• For a lower microwave power, press pads 1 (for 10%) through 9 (for 90%).• Press any numeric key pad twice to set power level back to 100%.0 turns off the microwave power and cooking is by convection only.8. Press Stage pad.• Enter cook time, temp and power level as in steps 5, 6, and 7.• To enter another cooking stage for that pad, press Stage pad again. Up tofour different stages can be programmed.9. Press the Program Save pad to save the program and changes.NOTE: To discard changes, press Stop/Reset pad before pressing ProgramSave pad.ProgrammingPreheat SettingThe factory default preheat settingis 475°F (250°C). To program thepreheat setting oven must be ON:1. Press Program Save pad.2. Press Temp Entry pad.3. Enter desired temperature by usingthe numeric key pads.4. Preheat temperature is changed.Oven Wall ClearancesA—For North American (UL/CSA) models, allow at least 2” (5.1 cm) of clearance around top of oven.For International (50 Hz) models, allow at least 7” (17.8 cm) of clearance around top of oven.Proper air flow around oven cools electrical components. With restricted air flow, oven may notoperate properly and life of electrical parts is reduced.B—Allow at least 2 9/16” (6.5 cm) between air discharge on back of oven and back wall.C—Allow at least 1 1/4” (3 cm) of clearance around sides of oven.PreprogrammedPadsTo cook food usingpreprogrammed cooking sequences.1. Open oven door and place foodin oven. Close door.2. Press desired pad.3. Oven begins to cook.4. At end of cooking cycle oven beepssignaling food is done.No popcornON/OFF TIME ENTRY POWER LEVELSTAGEPROGRAM SAVETEMP ENTRYThis guide covers model: ACE*

/ 2

Related manuals for ACP ACE series