©2019 ACP, Inc.Cedar Rapids, IA 52404Page 5 of 11Part No. 20267601Original InstructionsGrounding/Earthing InstructionsOven MUST be grounded. Grounding reduces risk of electric shock byproviding an escape wire for the electric current if an electrical shortoccurs. This oven is equipped with a cord having a grounding wire witha grounding plug. The plug must be plugged into an outlet that isproperly installed and grounded.Consult a qualified electrician or servicer if grounding instructions are not completely understood, or if doubt exists as to whetherthe oven is properly grounded.Do not use an extension cord.If the product power cord is too short, have a qualified electrician install a three-slot receptacle. This oven should be plugged intoa separate circuit with the electrical rating as provided in product specifications (available at www.acpsolutions.com). When amicrowave oven is on a circuit with other equipment, an increase in cooking times may be required and fuses can be blown.EXTERNAL EQUIPOTENTIAL EARTHING TERMINAL (EXPORT ONLY)Equipment has secondary earthing terminal. Terminal provides external earthing connection used in addition to earthingprong on plug. Located on outside of oven back, terminal is marked with symbol shown at rightUnpacking Oven• Inspect oven for damage such as dents in door or inside oven cavity.• Report any dents or breakage to source of purchase immediately.Do not attempt to use oven if damaged.• Remove all packing materials from oven interior.• If oven has been stored in extremely cold area, wait a few hours beforeconnecting power.Radio InterferenceMicrowave operation may cause interference to radio, television. Reduce or eliminateinterference by doing the following:• Clean door and sealing surfaces of oven according to instructions in “Care andCleaning” section.• Place radio, television, etc. as far as possible from oven.• Use a properly installed antenna on radio, television, etc. to obtain stronger signalreception.Oven Placement• Do not install oven next to or above source of heat, such as pizza ovenor deep fat fryer. This could cause oven to operate improperly and could shortenlife of electrical parts.• Do not block or obstruct oven filters. Allow access for cleaning.• Install oven on level counter-top surface.• Place warning label in a conspicuous place close to microwave oven.• Outlet should be located so that plug is accessible when oven is in place.OVEN CLEARANCESA. Allow at least 7” (17.78 cm) of clearance around top of oven. Proper air flowaround oven cools electrical components. With restricted air flow, oven may notoperate properly and life of electrical parts is reduced.B. There is not an installation clearance requirement for the back of the oven.C. Allow at least 1” (2.54 cm) of clearance around sides of oven.D. Install oven so oven bottom is at least 3 feet (91.5 cm) above floor.⚠ WARNINGTo avoid risk of electrical shock ordeath, this oven must be groundedand plug must not be altered.InstallationABCDABCD