©2019 ACP, Inc.Cedar Rapids, IA 52404Part No. 20267702Original InstructionsQuick Start GuideRefer to Owner’s Manual for Safety Statements. Complete Owner’s Manual available online.This document covers RMS*A and MMS*A models with touchpad controlsABCDOVEN CLEARANCESA. Allow at least 7” (17.78 cm) of clearance around top of oven. Proper air flowaround oven cools electrical components. With restricted air flow, oven may notoperate properly and life of electrical parts is reduced.B. There is not an installation clearance requirement for the back of the oven.C. Allow at least 1” (2.54 cm) of clearance around sides of oven.D. Install oven so oven bottom is at least 3 feet (91.5 cm) above floor.Preset Program KeysTo cook food using preprogrammedcooking sequences:1. Open oven door and place food inoven. Close door.2. Press desired Number Key3. Oven begins cooking4. At the end of the cooking cycle,the oven beeps and LED displays“End”.X2 - Double QuantityCooking1. Open oven door and place food inoven. Close door.2. Press X2 key .3. Press desired Preset ProgramNumber Key(s). LED displays thecooking time for two quantities.The oven will start cooking per thequantity preset cooking time.The switching operation of this microwave oven can cause voltage fluctuations on the supply line. The operation of this oven under unfavorablevoltage supply conditions can have adverse effects. This device is intended for the connection to a power supply system with a maximumpermissible system impedance Zmax of 0.2 Ohms at the interface point of the user’s supply. The user has to ensure that this device is connectedonly to a power supply system which fulfills the requirement above. If necessary, the user can ask the public power supply company for thesystem impedance at the interface point.So…how do I use it? (Electronic Control)Manual Time Entry ModeTime entry mode allows the user to manually enter a cook time and power level.1. Open oven door and place food in oven. Close door.2. Press the TIME ENTRY key .3. Press Number Keys to enter the desired cook time.4. Press POWER LEVEL key , , or to change power level if desired.5. If stage cooking is desired, press TIME ENTRY key and repeat steps 2-4.6. Press START key to begin cooking.7. At the end of the cooking cycle, the oven beeps and LED displays “End”.Programming Mode1. Open oven door and press and hold Number Key “1” for 5 seconds.2. Press a Number Key to change or review a Preset Program setting.3. Press Number Keys to enter the new desired cook time.4. Press POWER LEVEL key , , or to change power level if desired.5. If stage cooking is desired, press TIME ENTRY key and repeat steps 3-5.6. Press START key to save the cooking program.7. Close the door to exit Programming Mode.Note: If STOP/RESET key is pressed before programming iscomplete,changes are discarded and microwave exits programming mode.