ADC Gas Electric Steam AD-26 User Manual

Contents

ADC Gas Electric Steam AD-26 User Manual Manual pdf 14 page image

12C. FREE DRY MODE1 When turning on power or when no cycle is in progress, the light emitting diode (L.E.D.) display will read“FILL” and/or “FrEE.”2. Select temperature. The dryer will start, the L.E.D. display will read the temperature cycle selected andthe drying time portion of the L.E.D. display will read the temperature cycle selected. The drying timeportion of the L.E.D. drying will read “00” and count upward as time elapses, or the vended time will countdownward, depending on which parameter is programmed.NOTE: If the door is opened during a cycle, both the heat and motor will stop. However, the Phase 5coin microprocessor controller (computer) will continue to count the time, either upward ordownward, depending on which parameter is programmed. Continuation of the cycle willresume only after the door has been closed and any one (1) of three (3) temperature selectionbuttons is again depressed.3. Once the preprogrammed percent dryness level and cool down period has been reached or maximumautomatic time has expired, whichever comes first, the tone (buzzer) will sound, and the L.E.D. display willread “donE” for 5-seconds, at which time the dryer will shut off.NOTE: If the Anti-Wrinkle Program is active (“Grd”), the L.E.D. display will remain reading “donE,”and the Phase 5 coin microprocessor controller (computer) will proceed through theAnti-Wrinkle Program until the maximum “Guard On Time” has expired or door is opened,whichever comes first. The L.E.D. display will read “FILL” and/or “Amount To Start”(“AtSt”).NOTE: If the Anti-Wrinkle Program is not active (“nGrd”), the L.E.D. display will read “donE” untilthe main door is opened, at which time the L.E.D. display will read “FILL” and/or “Amount ToStart.”