ADC Gas Electric Steam AD-26 User Manual

Contents

ADC Gas Electric Steam AD-26 User Manual Manual pdf 18 page image

16ANTI-WRINKLE PROGRAM (Grd)This feature can be used in conjunction with any of the three (3) operating modes (Coin Mode, Auto Mode, orthe Free Dry Mode). In this program (“Grd”), when the drying and cooling cycles are completed, the dryer willshut off, the buzzer (tone) will sound, and the light emitting diode (L.E.D.) display will read “donE.” If the dooris not opened, the Phase 5 coin microprocessor controller (computer) will wait until the “Guard Delay Time”(PL15) has expired, at which time the clothes will be tumbled (without heat) for the programmed ”Guard OnTime” (PL15). The Phase 5 coin microprocessor controller (computer) will repeat this process until theprogrammed “Active Guard Time” (PL16) has expired or until the dryer door is opened, at which time theL.E.D. display will read “FILL” and/or “Amount To Start” (“AtSt”) or “FILL” and/or “FrEE.”NOTE: When programming the use of the Anti-Wrinkle Program (“Grd”), the following parameter/programs need to be checked and/or changed accordingly:PL01 ................................ “Grd” (Anti-Wrinkle Program active)................................ “bUZ” or “nbUZ” (buzzer [tone] active/not active)PL15 ................................ “GdLY” (guard delay time)................................ “Gont” (guard on time)PL16 ................................ “AGt” (active guard time)BUZZ/TONE (bUZ)With the Anti-Wrinkle Program active, the option is available to have the buzzer/tone (“bUZ”) sound for a periodof 5-seconds at the end of each “Guard On Time” cycle, or, no buzzer (“nbUZ”) sound.FREE DRY MODE (FrEE)The Phase 5 coin microprocessor controller (computer) can be programmed to run without the insertion ofcoins. When the Phase 5 coin microprocessor controller (computer) is in the “FrEE” dry mode, it may beprogrammed to run in the “AUtO” (Automatic) Mode or the “tInE” (Timed) Mode.NOTE: When programming the use of the Free Dry Mode (“FrEE”), the following parameters/programs need to be checked and/or changed accordingly;PL01 ................................ “AUtO” (automatic drying cycle) or................................ “tInE” (timed drying cycle) “FrEE”PL02* .............................. “PdrY” (percent dry)PL14* .............................. “Adrt” (maximum auto dry time)PL17* .............................. “A” and “b” factors* Needs to be programmed only if PL01 “AUtO” Cycle is chosen.