ADJ 32 HEX PANEL IP User Manual

Also see for 32 HEX PANEL IP: User instructions

24D M X S E T U PAll fixtures should be given a DMX starting address when using a DMX controller, to ensure that thecorrect fixture responds to the correct control signal. This digital starting address is the channel num-ber from which the fixture starts to “listen” to the digital control signal sent out from the DMX control-ler. This starting DMX address is assigned by setting the correct DMX address on the digital controldisplay on the fixture.You can set the same starting address for all fixtures or a group of fixtures, or set different addressesfor each individual fixture. Setting all fixtures to the same DMX address will cause all fixtures to reactin the same way; in other words, changing the settings of one channel will affect all the fixtures simul-taneously.If you set each fixture to a different DMX address, each unit will start to “listen” to the channel numberyou have set, based on the quantity of DMX channels of each fixture. That means changing the set-tings of one channel will only affect the selected fixture.For example, when in 6 channel mode you should set the starting DMX address of the first unit to 1,the second unit to 7 (1 + 6), the third unit to 13 (1 + 6 + 6), and so on. Please refer to the chart below.Channel Mode Unit 1 Address Unit 2 Address Unit 3 Address Unit 4 Address6 channel 1 7 13 198 channel 1 9 17 2510 channel 1 11 21 3111 channel 1 12 23 3416 channel 1 17 33 4948 channel 1 49 97 14557 channel 1 58 115 17296 channel 1 97 193 289