ADJ ELECTRAPIX BAR 8 User Manual

25This unit can be operated using the ADJ UC IR24 remote control. The unit can only be controlledwhen it has been set to Primary mode. The unit will NOT respond to commands when it hasbeen set to Secondary mode. When using the UC IR to control multiple units that are operating inprimary/secondary mode, follow these steps to set up the units:1. Power on the unit, and press MODE to scroll to the “Personality” menu, then press SETUP.2. Use the UP and DOWN buttons to scroll to “Prim/Sec Mode”. Press SETUP, then use the UP andDOWN buttons set the device to “Primary”. The unit will NOT respond to IR remote commands whenit has been set to “Secondary” mode.3. Press SETUP to confirm and return to the “Personality” menu.4. Use UP and DOWN to scroll to “IR Function” and press SETUP.5. Use the UP and DOWN buttons to scroll to “ON”, then press SETUP to confirm.CONTROLS• On: Fixture turns on and reverts to the last running state• Off: Fixture goes into stand by mode in a blackout state.• Strobe: Actives strobe mode. The strobe rate can be adjusted using the + / - buttons.• Sound: This button has no defined function for this unit.• Color: Activates color mode. Select a static color (0-15) using the number keys. The intensity forthe set color can then be adjusted with the +/- buttons.• Program: Activates program mode. Select an internal program (0-15) using the number keys. Theselected program run speed can be adjusted with the +/- buttons. Note: 13 of the 15 buttons willactivate a program for this unit.• + and - buttons: Adjusts strobe rate, mic sensitivity, intensity, or program run speed. The +/- but-tons can be repeatedly pressed to increase or decrease by individual level increments, or pressedand held to quickly make large adjustments at once.• Number Keys (0-15): These buttons are used to select preset static colors and internal programs.Colors stored in the number keys can be edited from the units menu if desired.U C I R R E M O T E