26BUTTON RED GREEN BLUE AMBER LIME UV0 255 255 255 255 0 01 255 0 0 0 0 02 0 255 0 0 0 03 0 0 255 0 0 04 255 46 0 0 0 05 0 255 28 0 0 06 17 0 75 0 0 07 255 83 0 63 0 08 0 255 52 0 0 09 32 0 75 22 0 010 0 0 0 255 0 011 0 114 160 0 0 012 100 0 97 0 0 013 255 255 0 255 0 014 0 75 136 0 0 015 146 0 80 0 0 0E D I T I N G I R B U T T O N VA L U E SThese fixtures allow the user to create custom RGBAL+UV values and assign them to the numberedkeys (0-15) on the remote control. Follow the steps below:1. In the main system menu, press MODE to navigate to “Personality,” then press SETUP. Use the UPand DOWN buttons to scroll to “IR Button Colors,” then press SETUP again.2. Use the UP and DOWN buttons to scroll to the number of the remote button that you would like touse. Options range from “Button 0” to “Button 15.” Press SETUP to select the button shown on thedisplay screen.3. Create a custom color for the button you have selected by using the UP and DOWN buttons to scrollthrough the color component options (Red, Green, Blue, Amber, Lime, or UV). Press SETUP toselect a color component option, then use the UP and DOWN buttons to adjust the intensity of thatcolor component option. Selectable values range from 000 to 255. Repeat this process until you haveset the desired Red, Green, Blue, Amber, Lime, and UV intensities to create your custom color.NOTE: Once you have created and assigned a custom RGBAL+UV value to a remote button, thedefault color for the remote button will be overridden. This means that the output color of thefixture may no longer resemble the color shown on the remote button. The only way to return tothe default RGBAL+UV value is to reset the unit to the default factory settings by navigating toPersonality > Service > Factory Restore.NOTE: If multiple units have been linked in a primary-secondary set up, the custom RGBAL+UVvalues only need to be set up on the primary unit. The custom RGBA settings will carry overautomatically to any secondary units in the system.L+UVI R D E FA U LT VA L U E S