17G O B O SREPLACEMENT PROCEDURE1. Place the device on a flat, stable surface, and allow the device to cool down for at least 1 hourbefore beginning this procedure.2. Engage both the pan and tilt locks, and remove the head covers.3. Locate the gobo module, which is the second module from the bottom, as shown in the illustrationbelow. Disconnect any electrical connectors linking the module to the fixture head, and remove thescrews holding the module in place. Slide the module out of the head.4. Pull the gobo holder away from the gobo wheel, then gently slide it outwards. Use a pair of needlenose pliers to carefully remove the retainer spring from the gobo holder. The gobo can now beremoved from the gobo holder, and replaced with a new gobo. Reassemble by reversing thesesteps.

ADJ HYDRO SPOT 2 User Manual