ADJ HYDRO SPOT 2 User Manual

Also see for HYDRO SPOT 2: User manual

24D M X S E T U PDMX ADDRESSING.All fixtures should be given a DMX starting address when using a DMX controller, so the correct fix-ture responds to the correct control signal. This digital starting address is the channel number fromwhich the fixture starts to “listen” to the digital control signal sent out from the DMX controller. Theassignment of this starting DMX address is achieved by setting the correct DMX address on the digi-tal control display on the fixture.You can set the same starting address for all fixtures or a group of fixtures, or set different addressesfor each individual fixture. Setting all fixtures to the same DMX address will cause all fixtures to reactin the same way. In other words, changing the settings of one channel will affect all the fixtures simul-taneously.If you set each fixture to a different DMX address, each unit will start to “listen” to the channel numberyou have set, based on the quantity of DMX channels of each fixture. That means changing the set-tings of one channel will only affect the selected fixture.For example, when this unit is operating in 24 channel mode, you should set the starting DMXaddress of the first unit to 1, the second unit to 25 (1 + 24), the third unit to 49 (1 + 24 + 24), and soon. See the chart below for more details.CHANNEL MODE UNIT 1 ADDRESS UNIT 2 ADDRESS UNIT 3 ADDRESS UNIT 4 ADDRESS24 Ch 1 25 49 7329 Ch 1 30 59 8836 Ch 1 37 73 109