ADJ HYDRO SPOT 2 User Manual

Also see for HYDRO SPOT 2: User manual

37M A I N T E N A N C E G U I D E L I N E SDISCONNECT POWER BEFORE PERFORMING ANY MAINTENANCE!CLEANINGFrequent cleaning is recommended to ensure proper function, optimized light output, and an extend-ed life. The frequency of cleaning depends on the environment in which the fixture operates: damp,smoky, or particularly dirty environments can cause greater accumulation of dirt on the fixture’s optics.Clean the external lens surface regularly with a soft cloth to avoid dirt/debris accumulation.NEVER use alcohol, solvents, or ammonia-based cleaners.MAINTENANCERegular inspections are recommended to ensure proper function and extended life. There are nouser serviceable parts inside this fixture. Please refer all other service issues to an authorized ADJservice technician. Should you need any spare parts, please order genuine parts from your local ADJdealer.Please refer to the following points during routine inspections:A. A detailed electrical check by an approved electrical engineer every three months, to make surethe circuit contacts are in good condition and prevent overheating.B. Be sure all screws and fasteners are securely tightened at all times. Loose screws may fall outduring normal operation, resulting in damage or injury as larger parts could fall.C. Check for any deformations on the housing, color lenses, rigging hardware, and rigging points(ceiling, suspension, trussing). Deformations in the housing could allow for dust to enter into thefixture. Damaged rigging points or unsecured rigging could cause the fixture to fall and seriouslyinjure a person(s).D. Electric power supply cables must not show any damage, material fatigue, or sediments.NEVER remove the ground prong from the power cable.SOFTWARE UPDATESFor software updates, please contact ADJ service to obtain a software uploader and detailed instruc-tions. Refer to the Introduction section of this manual for contact information.FIXTURE DISASSEMBLYThe following points should be observed after performing any maintenance procedure that requiresdisassembly of the unit:• After the unit has been reassembled, open the valve, and allow the light to run for approximately 2hours in order to dry out any moisture that has been trapped inside the fixture. The process shouldcontinue until indicated humidity drops below 15% for the head and 30% for the base.• Once this has been achieved, the light can be switched off, but the unit should remain connectedto power so that the cooling fan can cool down the unit. Please note that allowing cool down timeshould ALWAYS be done after lamp operation.• Some units may require partial disassembly in order to gain access to the valve. Please contactADJ service for information regarding the location and access procedure for the valve on yourspecific unit model.