ADJ Stinger Gobo User Instructions

ADJ Products, LLC - www.adj.com - Stinger Gobo Instruction Manual Page 5ADJ Products, LLC - www.adj.com - Stinger Gobo Instruction Manual Page 4Safety Issues: This unit may “pop” the fuse if the maximum allottedload of 2 amps is reached.• To reduce the risk of electrical shock or fire, do not expose this unitrain or moisture.• Do not spill water or other liquids into or on to your unit.• Do not attempt to remove or break off the ground prong from theelectrical cord. This prong is used to reduce the risk of electricalshock and fire in case of an internal short. Do not attempt to oper-ate this unit if the power cord has been frayed or broken.• Disconnect from main power before making any type of connection.• Do not remove the cover under any conditions. There are no userserviceable parts inside.• Always be sure to mount this unit in an area that will allow properventilation. Allow about 6” (15cm) between this device and a wall.• Do not attempt to operate this unit, if it becomes damaged.• This unit is intended for indoor use only, use of this product out-doors voids all warranties.• During long periods of non-use, disconnect the unit’s main power.• Always mount this unit in safe and stable matter.• Power cords should be routed so they are not likely to be walkedon, pinched by items placed upon or against them.• Cleaning -The fixture should be cleaned only as recommended bythe manufacturer. See page 21 for cleaning details.• Heat -The appliance should be situated away from heat sourcessuch as radiators, heat registers, stoves, or other appliances(including amplifiers) that produce heat.• The fixture should be serviced by qualified service personnel when:A. The power-supply cord or the plug has been damaged.B. Objects have fallen, or liquid has been spilled into the unit.C. The unit has been exposed to rain or water.D. The unit does not appear to operate normally or exhibits amarked change in performance.! !LASER RADIATION AVOIDDIRECT EYE EXPOSUREMaximum output <5 mWWavelength: 405, 532nmClass IIIa laser productThis device complies with 21 CFR chapter I,Subchapter J, or CFR 1040.10 and 1040.11Stinger Gobo Safety PrecautionsNON-INTERLOCKED HOUSING WARNINGThe Royal Sky contains high power laser devices internally. Do notopen the laser housing, due to the potential exposure to unsafe levelsof laser radiation. The laser power levels, if the unit is opened, cancause instant blindness, skin burns and fires.STOP AND READ ALL LASER SAFETY DATAOPERATION INSTRUCTIONS AND LASER SAFETYThe light source emitted from this product can potentially cause eyeinjury if not set up and used properly. The light source emitted from alaser is very different from any other light sources with which you maybe aware of. Laser light is thousands of times more concentratedthan any light from any other kind of light source. This concentrationof light can cause instant eye injuries, primarily by burning the retina(the back of your eyeball contatining cells that are sensitive to light).Even if you cannot feel “heat” from a laser beam, it can still poten-tially injure or blind you or your audience. Even very small amountsof laser beam light are potentially hazardous even at long distances.Laser eye injuries can be sustained faster than you can blink.Do not think that because this laser splits the laser beam into hun-dreds of beams and that the laser beam is scanned out in highspeed, that an individual laser beam is safe for eye exposure. Thislaser uses dozens of milliwatts of laser power (Class 3B levels inter-nally) before it splits into multiple beams (Class 3R levels). Many ofthe individual beams are potentially hazardous to the eyes.Do not that because the laser light is moving, it is safe. This is nottrue. Nor, do the laser beams always move. Since eye injuries canoccur instantly, it is critical to prevent even the smallest possibility ofany direct eye exposure. In the laser safety regulation, it is not legalto aim Class 3R lasers in areas which people can get exposed. Thisis true even if it is aimed below people’s faces, such as on a dancefloor.Do not operate the laser without first reading and understandingall safety and technical data in this manual.Always set up and install all laser effects so that all laser light is atleast 3 meters (9.8 feet) above the floor on which people can stand.Stinger Gobo Laser Warnings and Safety