ADJ Stinger Gobo User Instructions

ADJ Products, LLC - www.adj.com - Stinger Gobo Instruction Manual Page 14 ADJ Products, LLC - www.adj.com - Stinger Gobo Instruction Manual Page 15Stinger Gobo System MenuNODN - This mode can be used as a precaution mode,that in case the DMX signal is lost, interrupted, or power islost, the operating mode chosen in the setup is the runningmode the fixture will go into when the DMX signal is lost. Youcan also set this as the operating mode you would like theunit to return to when power is applied.1. Press the MENU button until “NODN” is displayed, and either“MASL”, “BLND”, or “LAST” will be displayed beneath.2. Press ENTER and the bottom choice will begin to flash. Use the UPor DOWN buttons to choose an operating mode you would like the unitto start up in when power is applied or the DMX signal is lost.• HOLD - If the DMX signal is lost the fixture will stay in the last DMXsetting. If power is applied and this mode is set, the unit will automati-cally go into the last DMX set up.• PRGN (Master Slave) - If the DMX signal is lost or power is applied,the unit will automatically go into Master Slave mode and run a built-inshow.• BLAC (Blackout) - If the DMX signal is lost or interrupted, the unit willautomatically go into stand by mode.3. Press ENTER to confirm your desired set up.LED - With this function you can have the LED displayturn off after 10 seconds.1. Press the MENU button until “LED” is displayed, press ENTER.2. The display will show either “ON” or “OFF”. Press the UP orDOWN buttons to select “ON” to keep the LED display on at alltimes, or “OFF” to switch to have the LED display switch off after 10seconds.STRO - This will activate strobing.1. Press the MENU button until “STRO” is displayed, press ENTER.Stinger Gobo System Menu2. A number between 0-100 will now be displayed, the number is thecurrent speed setting. Use the UP or DOWN buttons to adjust theshow speed. “0” being the slowest speed and “100” being the fastest.3. Press ENTER to set the speed then press and hold the MENUbutton for at least 3 seconds to show mode.SLND - This will let you set unit as a master or slave in amaster/slave configuration.1. Press the MENU button until “SLND” is displayed, press ENTER.Either “MAST”, “SL 1”, or “SL 2” will be displayed.2. Press the UP or DOWN buttons until your desired setting is dis-played, press ENTER to confim.NoTE: In a Master/Slave configuration you can set one fixture toMaster and then set the next fixture to “SL 2”, the fixtures will nowhave contrast movement to each other.SOUN - Sound Active mode.1. Press the MENU button until “SOUN” is displayed, press ENTER.2. The display will show either “ON” or “OFF”. Press the UP orDOWN buttons to select “ON” to activate sound active mode, or“OFF” to deactivate sound active mode.3. Press ENTER to confirm.SOSE - In this mode you can adjust the sound sensitiv-ity.1. Press the MENU button until “SOSE” is displayed, press ENTER.2. A number between 0-100 will be displayed. Press the UP or DOWNbuttons to adjust the sound sensitivity. 0 being the least sensitive,and 100 being the most sensitive.3. When you have found your desired setting press ENTER to confirm.