ADLINK Technology NuPRO-590 Series User Manual

ADLINK Technology NuPRO-590 Series User Manual Manual pdf 61 page image

Bios Configuration • 53To load SETUP defaults value to CMOS SRAM, enter “Y”. If not,enter “N”♦ Integrated PeripheralsThis option sets your hard disk configuration, mode and port.ROM PCI/ISA BIOSINTEGRATED PERIPHERALSPAWARD SOFTWARE INC.IDE HDD Block Mode : Enabled UART Mode Select : NormalIDE Primary Master PIO : Auto UART2 Duplex Mode : FullIDE Primary Slave PIO : Auto RxD , TxD Active : Hi , HiIDE Primary Master UDMA : Auto IR Transmission delay : DisabledIDE Primary Slave UDMA : Auto Onboard Parallel Port : 378/IRQ7IDE Secondary Master PIO : Auto Parallel Port Mode : SPPIDE Secondary Slave PIO : Auto ECP Mode Use DMA : 1IDE Secondary Master UDMA : Auto EPP Mode Select : EPP1.9IDE Secondary Slave UDMA : AutoOn-Chip Primary PCI IDE : EnabledOn-Chip Secondary PCI IDE : EnabledUSB Keyboard Support : DisabledCOM2 Mode Select : RS232Onboard Lan Chip : EnabledOnboard VGA Chip : EnabledESC : Quit · ‚ fl : Select ItemKBC input clock : 6 MHz F1 : Help PU/PD/+/- : ModifyOnboard FDC Controller : Enabled F5 : Old Values (Shift) F2 : ColorOnboard Serial Port 1 : 3F8/IRQ4 F6 : Load BIOS DefaultsOnboard Serial Port 2 : 2F8/IRQ3 F7 : Load Setup DefaultsIDE HDD Block ModeThis field allows your hard disk controller to use the fast block mode totransfer data to and from your hard disk drive.Enabled IDE controller uses block modeDisabled IDE controller uses standard modeIDE Primary/Secondary Master/Slave PIOThese fields allow your system hard disk controller to work faster. Ratherthan have the BIOS issue a series of commands that transfer to or from thedisk drive, PIO (Programmed Input/Output) allows the BIOS to communicatewith the controller and CPU directly.The system supports five modes, numbered from 0 (default) to 4, whichprimarily differ in timing. When Auto is selected, the BIOS will select the bestavailable mode.