ADT Network Camera User Manual
                                                   | |
Contents
| 
Network Camera35System EventCheck the System Event box to set up a system event. The camera checks and reports thesystem status and SD memory card on or off. System Alive Message: Check the box to check the system operation, and select thecheck interval.− Send Email: Check the box to send an email when the system is operating.− Remote Callback: Check the box and select the remote systems to send a message whenthe system is operating (Not supported for the WebGuard program). Disk In/Out: Check the box to send notices if an SD memory card is inserted or removed.− Send Email: Check the box to send an email when the SD memory card is inserted to orremoved from the camera.− Remote Callback: Check the box and select the remote systems to send a message when theSD memory card is inserted to or removed from the camera (Not supported for the WebGuardprogram).NOTE: You must properly configure the Email and Remote Callback settings whensetting them up to send an email or a message. Refer to the Event Action setup. |
Related manuals for ADT Network Camera
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine