ADTRAN 1200051L1 User Manual

Also see for ISU 2x64: Using Specifications

Contents

ADTRAN 1200051L1 User Manual Manual pdf 49 page image

Chapter 6. Configuration61200051L1-1D ISU 2x64 Dual Port ISDN Service Unit User Manual 35RS-366 parallel dialing port, configure the unit for RS-366 dialing.(See Figure 6-4.) This enables the RS-366 port on the rear of theunit. Whenever this dialing mode is enabled, data terminal ready(DTR) must be active before a call is placed. The call may be dis-connected by dropping DTR, or from the front panel by selectingthe # (pound) key to go directly to the Dial menu and selecting1=Hang up line, then Enter.DTE RS-366 dialers can end their string of dialed numbers in twodifferent ways. The end of number (EON) alerts the ISU 2x64that the entire number has been sent. Another method is to sim-ply stop sending numbers and allow the ISU 2x64 to time out,then dial the number. The ISU 2x64 supports both methods ofdialed number terminations. The following options allow thedialed number termination to be fine-tuned:Figure 6-4Dial Options, RS-366 Menu Tree1 sec or EON: The ISU 2x64 assumes the dial string is fully entered if more thanone second elapses since the last digit was keyed, or the unitreceives the EON command.2 sec or EON: The ISU 2x64 assumes the dial string is fully entered if more thantwo seconds elapse since the last digit was keyed, or the unitreceives the EON command.5 sec or EON (def): The ISU 2x64 assumes the dial string is fully entered if more thanfive seconds elapse since the last digit was keyed, or the unitreceives the EON command. This is the factory default setting.10 sec or EON: The ISU 2x64 assumes the dial string is fully entered if more than10 seconds elapse since the last digit was keyed, or the unitreceives the EON command.3=CONFIG1=Netw. options2=DTE options3=Protocol4=Quick setup5=Security6=Remote Config1=Dial Line2=Leased Line1=Switch protocl2=Call type3=Terminal ID4=Busy Out5=Dial options6=Auto answer7=Answer tone8=Connect Timout9=Call Screening10=SBus Terminati1=Front Panel2=RS-3663=AT commands4=V.255=Disabled1=1 sec or EON2=2 sec or EON3=5 sec(default)4=10 sec or EON5=20 sec or EON6=Wait for EON