61200770E1-31C Copyright © 2009 ADTRAN, Inc. 61APPENDIX A. CONFIGURATION AND LINE PARAMETERSThe following tables list all of the parameters found in the configuration files downloaded to each phone atboot up. Table 12 spans several pages and covers the Configuration Parameters. Table 13 on page 80covers only the Line Parameters. The Source column defines the methods that can be used to change or setthe parameter including editing the configuration file, manually entering the setting from the phone’s userinterface, accessing the settings through the administrator’s Web interface, or using DHCP site-specificoption. The default settings are called out in the Description column. If no default is given, there is nodefault setting present for that command.Table 12. Configuration ParametersParameter Value Type Description SourcesAdminPassword ASCIIStringSets the message digest 5 (MD5)hash of the password to access theadministrator’s Web page. Thispassword is saved in flash memoryafter a value has been received in aconfig file so it can be enforced onsubsequent reboots. It is cleared bythe restore factory defaults command.Only the password in the hashedstring can be changed. Theadmin:Adtran: part cannot bechanged.Default: MD5 hash of“admin:Adtran:password”Config FileAlertSelect 0 to 2 Sets the policy for handling apreselected line on an idle phonewhen it rings.0=No selection change1=Select upon audible alert (default)2=Select away to eligible idlepreferenceConfig FileWeb InterfaceAppName ASCII StringCharactersIndicates the name of the applicationimage in the phone. The applicationfile name can contain up to 24characters. The combination of filename and path can be up to 32characters long. A new applicationname is specified in a configurationfile and is checked against the versionin flash to decide if a new versionneeds to be downloaded.Config File