MX2800 M13 Multiplexer User Manual Transaction Language 1 (TL1), Section 961200290L1-1G 9-11* An asterisk indicates optional command blocks.TL1 Autonomous MessagesAutonomous messages provide a mechanism for real time reporting of system events. Although mostevents reported are alarms, some events are only informational. The Verb, Mod1, and Mod2 parameters ofthe message indicate what type of event has occurred.NOTEThe default setting for Autonomous message reporting is OFF.Follow these steps to enable Autonomous message reporting:• If it has not already been done, initiate a TL1 session by following the setup procedures and using theACT-USER command.• Use the ALW-MSG command to enable autonomous messaging. This command is described inTable 9-2 on page 9-6.REPT-ALM indicates an alarm event. Table 9-3 on page 9-12 lists possible autonomous messages foralarm events and includes recommended actions to take. REPT-EVT indicates an informational event.Table 9-4 on page 9-16 lists possible autonomous messages for informational eventsSET-DAT:::::,;Description Sets the date and timePARAM1 Date in YY-MM-DD formatPARAM2 Time in HH-MM-SS formatTable 9-2. TL1 Commands (Continued)
