MX2800 M13 Multiplexer User Manual Index61200290L1-1G I-5SNMP Management Options 3-21SNMP State 3-21SNMP State menu 3-21SNMP, overview 1-2specifications, MX2800 C-1Stand By, Card A/Card B 4-5State menu (DS3 State) 4-2State menus, T1/E1 3-9Statistics menu24 Hour Alarm History (DS2) 5-924 Hour Alarm History (DS3) 5-2Clear All T1/E1 Alarm Counts 5-13DS2 Statistics 5-9DS3 Statistics 5-2Performance Parameters (DS3) 5-4T1/E1 Statistics 5-13Statistics menus 5-1Status menuAlarm (DS3 State) 4-2Alarm (System State) 4-4Card A/Card B 4-5Card Comm 4-5DS2 State 4-6DS3 State 4-1Power Supply State 4-4Protection 4-5Remote 4-3Rx Framing 4-1State 4-2System State 4-4Subnet Mask menu 3-17Supply Failure, System State Alarm 4-4Switched, System State Alarm 4-4Syslog Setup menu 3-37system alarms 3-34System Name 3-25system reset 3-43System Security 3-26System Security menu 3-26System State AlarmCard Failure 4-4Excessive Switches 4-4Supply Failure 4-4Switched 4-4System State menu 4-4TT1/E1 Line Length menu 3-11T1/E1 menusLine Coding 3-10State 3-9T1/E1 StateCAIS 4-6HOT 4-6LAIS 4-6LOS 4-6OK 4-6TST 4-6XCV 4-6T1/E1 Statistics menu 5-13Telnet, overview 1-3Temp Critical, Power Supply State 4-4Temp High, Power Supply State 4-4terminal connection, establishing 2-9time, setting 3-33TL1alarm events 9-11autonomous messages 9-11commands 9-5Editing 9-17error codes 9-17informational events 9-11messages 9-3responses 9-3TLOS, State 4-2Transmission menu 3-37Trap Community Name 3-25Trap Generation menu 3-21Trap IP Addresses menu 3-21trapscontroller 3-22for calls between primary and secondary num-bers 3-19for redialing 3-19Tributary loopback 6-2TST, T1/E1 State 4-6UUnavailable Seconds (UAS) 5-8Unit ID Code menu 3-36Unknown, Remote state 4-3Utilities menu 3-38Vviewing statistical information 5-1WWrite Community Name 3-25
